Neighborhoods · South along I-405
Can't Find the Model Number on Your Kennydale Wolf Oven?
Kennydale is Renton's north end, where the ground rises from Lake Washington on both sides of I-405. When the Wolf in a Kennydale kitchen stops heating or lighting as it should, Wolf Repair Bellevue, (425) 629-0033, looks at it on an $89 visit that comes off the bill once you go ahead.
Where the lake view comes in
Kennydale dates back to 1898, which makes it one of the older corners of Renton. Lower Kennydale, between the freeway and the water, looks out across the lake toward the Bellevue skyline, and a kitchen with an outlook like that is the kind people tend to remodel around a good range.
That is how a Wolf usually arrives here: a dual fuel or all-gas range as the centerpiece of the new kitchen, or a built-in oven set into fresh cabinetry with a cooktop somewhere else on the counter.
Find the plate before you call
A remodel can leave an appliance several years old before anyone goes looking for its details. Open the oven door and look for the plate. On a dual fuel or GR range it is at the bottom of the control panel, far right.
On a built-in oven it is on the front frame, and the exact spot depends on the series, so check the lower trim, the left side and the strip just under the controls. Reading that number out on the phone lets the fault be narrowed down before anyone drives over.
Asked in Kennydale
- Is Kennydale too far south for a company based in Bellevue?
- Not at all. Kennydale is one of the Renton neighborhoods we cover, and a kitchen here is charged exactly as one in Bellevue: $89 for the visit and diagnosis, then a repair figure you agree to before anything is ordered. Call Wolf Repair Bellevue on (425) 629-0033 with your street and what the oven is doing.
- The range came with the house and there is no paperwork. Is that a problem?
- No. What we need is printed on the appliance itself: the rating plate carries the model and serial numbers, and those decide which genuine Wolf parts fit. Receipts and installer notes make no difference to the diagnosis. If the plate is awkward to read, the technician finds it and reads it at the start of the visit.
From Bellevue kitchens
What people say after the van leaves
4.9/ 5·1,283 reviews
Ran on high or not at all — low and medium did nothing. A dead speed switch and a chafed wire in the loom. He replaced both, and the quiet setting works again, which is all I ever wanted.
Rowena C.
Our dual-fuel oven was reading 350 and baking like 300. Turned out to be the temperature sensor drifting, not the board another company wanted to sell us. Fixed in one visit for a fraction of the quote.
Daniel & Kay P.
Both back burners lit slowly and sometimes with a small pop. Carbon-fouled electrodes, and one cap seated crooked. Fixed and explained properly. Four stars only because the first window slipped by an hour.
Maureen V.
Wolf service · Bellevue
A Wolf oven playing up in Kennydale?
Tell us the symptom on the phone and we will say what it usually turns out to be and whether it needs someone in the kitchen at all. The line is answered 24/7; technicians work daily, 8 am till 8 pm, weekends included.